Changed Motor Oil & Replaced Filter, Added Up To 5 QTS 0W20 Drydene Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
Visually inspect hoses, clamps, and belt, also pressure test cooling system for leaks. Drain and fill radiator with up to 1 gallon Of O-E eqivelent antifreeze.
Drain rear differential fluid. inspect for contamination. Replenish with factory spec oil
Loretta D. gave our service a 5 star review on 1/12/2024
Found both front lower control arm bushings torn and stabilizer bushing torn. Remove and replace both front lower control arms and stabilizer bushings.
Set toe, check ,camber and caster on all four wheels to factory specs.
Found Right Front bearing noisy. Remove hub to access bearing. Press in new bearing to new hub. Replace right front ABS sensor. Re-assemble all necessary parts. Road test vehicle. (overlapping labor with control arms)
Jack O. gave our service a 5 star review on 12/15/2023
Remove front disk brake pads and rotors. Clean all caliper slides, replace disk brake pads and disk brake rotors. Bleed air from system and road test vehicle.
Found main drive belt dry rotted. Removed, and replaced main drive belt
Brian M. gave our service a 5 star review on 9/15/2023
Changed Motor Oil & Replaced Filter, Added Up To 5 QTS 0W20 Drydene Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
Rotate tires and set tire pressure.
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Loretta D. gave our service a 5 star review on 6/22/2023
Found code P0339 for crank sensor. Found crank sensor losing signal, causing engine hesitation. Removed, and replaced crank sensor with OEM sensor. Reset ECM values.
Tune engine remove coils to acess and replace spark plugs with original O-E spark plugs. Reassemble and reset all codes and values in ecm.
Install fuel cleaner to gas tank-clean air intake system and clean throttle plate area-draw combustion chamber cleaner through Intake to remove deposits from valves. Clean injectors, fuel lines and remove water from tank to improve drivability, engine performance, fuel economy, and reduce emissions. Reset all codes and adaptive memories in ecm.
Visually inspect hoses, clamps, and belt, also pressure test cooling system for leaks. Drain and fill radiator with up to 1 gallon Of O-E eqivelent antifreeze.
Found main drive belt cracked, and dry rotted. Replaced main drive belt
Drain transmission fluid. Inspect fluid for contaminants and condition. Replenish fluid with O-E spec oil. Level off fluid and road test vehicle.
Gerry L. gave our service a 5 star review on 5/8/2023